These round basin covers are designed for interior and exterior applications where watertightness is not required. This is your most economical alternative to a traditional top slab for round concrete or fiberglass basins.

Useful Downloads

STANDARD FEATURES

Material: Aluminum, steel or stainless steel available
Frame: N/A
Covers: 1/4” diamond plate reinforced for 300 PSF Pedestrian loads
Hardware: All 316 SS nuts, bolts and washers
Hold-Open Device: N/A
Lock device: Staple for padlock protrudes through cover
Lift handle: Recessed lift handle(s) lay flush with top of cover
Warranty: Ten (10) years on aluminum, five (5) years on steel and stainless steel

Optional Features

• Nut rails with stainless steel sliding nuts for attaching cable holders, brackets & other hardware
• Custom lettering
• Anodized finish
• Covers to fit square or rectangular basins.
• Holes for vents, pipe couplings and other hardware
• Slip resistant surface bonded to cover plate
• All steel or stainless steel material

SPECIFICATIONS

The basin cover shall be Model BPC as manufactured by USF Fabrication, Inc. with the size being specified on the plans. Cover plate shall be 1/4-inch thick aluminum diamond plate reinforced for a 300 p.s.f. live load. The fixed section of the cover shall have three 5/8-inch diameter holes equally spaced on the perimeter to bolt it down to the structure. The access door shall be equipped with a flush lifting handle that does not protrude above the cover. The door shall have a 316 stainless steel continuous hinge and 316 stainless steel tamper proof bolts/locknuts, which allow the cover to open a full 180 degrees. A staple for a padlock shall be supplied for security. Installation shall be in accordance with the manufacturer’s attached instructions. The door shall be manufactured and assembled in the United States.