Angle frame floor access doors are the most economical solutions for interior or exterior applications where water intrusion is not a concern.

Useful Downloads

STANDARD FEATURES

Material: Aluminum, steel or stainless steel available
Frame: 1/4”material with integral anchoring systems
Covers: 1/4”diamond plate reinforced for 300 PSF Pedestrian loads
Hardware: All 316 SS nuts, bolts and washers
Hold-Open Device: 316 SS Hold-open arm with secondary latch mechanism
Lock device: Staple for padlock protrudes through cover
Lift Handle: Recessed aluminum lift handle lays flush with top of cover
Warranty: Ten (10) on aluminum, five (5) years on steel and stainless steel

Optional Features

• Stainless steel horizontal springs for easy opening
• 316 Stainless steel watertight slamlock and other locking devices
• Frame skirts for easy casting into a concrete top slab
• Nut rails with stainless steel sliding nuts for attaching cable holders, brackets & other hardware
• Fiberglass insulation with metal liner
• Custom lettering
• Stainless steel safety chains with aluminum support posts
• Fall Through Protection Systems
• Hot dipped galvanized finish
• Mill finish (no shop primer)
• All 304 stainless steel material
• All 316 stainless steel material
• Slip resistant surface bonded to cover plate
• Reading Lid

SPECIFICATIONS

The floor access door shall be Model APS as manufactured by USF Fabrication, Inc. with the size being specified on the plans. Door leaves shall be 1/4-inch thick aluminum diamond plate reinforced to a 300 p.s.f. live load. The frame shall be extruded aluminum with an integral anchor flange and door seat on all four sides. The floor access door shall be equipped with a flush lifting handle that does not protrude above the cover, and 316 stainless steel hold open arms with secondary latch mechanism that automatically keep the covers in their upright, open positions. The door shall have 316 stainless steel hinges with 316 stainless steel tamper resistant bolts/locknuts. A staple for a padlock shall be supplied for security. Installation shall be in accordance with the manufacturer’s attached instructions. The door shall be manufactured and assembled in the United States.